Tchater maintenant avec le support
Tchattez avec un ingénieur du support

syslog-ng Store Box 7.0.4 LTS - Deploying on Azure

Introduction

The aim of this guide is to provide detailed, step-by-step instructions on how to set up and install syslog-ng Store Box in a Microsoft Azure virtual environment.

The document comprises the following sections:

  • Prerequisites collects the requirements that you must comply with before deploying SSB on Microsoft Azure.

  • Limitations lists the limitations that apply when installing SSB in a Microsoft Azure virtual environment.

  • Deploying SSB on Microsoft Azure describes how to install SSB in a Microsoft Azure virtual environment.

Prerequisites

The following prerequisites must be met before deploying SSB on Microsoft Azure:

  • You have a valid One Identity syslog-ng Store Box license.

    syslog-ng Store Box uses the "Bring your own license" model. Note that to deploy two active SSB nodes as an availability set, you must purchase two standalone SSB licenses. To purchase a license, contact our Sales Team.

  • You have a Microsoft Azure account.

  • You have secure access to your Microsoft Azure Virtual Network resources, for example, through the use of a Virtual Private Network (VPN).

  • You have working knowledge of the SSB installation process.

  • You are familiar with Microsoft Azure.

Limitations

The following limitations apply when deploying SSB on Microsoft Azure:

  • SSB High Availability operation mode is not available. If High Availability (HA) operation mode is required in a virtual environment, use the HA function provided by the virtual environment.

  • Hardware-related alerts and status indicators of SSB may display inaccurate information, for example, display degraded RAID status.

  • When running SSB in a virtual environment, it is sufficient to use a single network interface.

  • During Microsoft Azure installation, connecting directly to the Internet using a public IP address is not supported. Instead, you must access the Internet via a Virtual Private Network or a jump host.

  • By default, the disk size of the virtual disk is 10 GiB. If you want to increase the disk size later, see Increasing the virtual disk size of SSB under a virtual machine in the Installation Guide.

  • SSB only supports the use of OS disks. It does not support the use of data disks or temporary disks and therefore these cannot be used.

Deploying SSB on Microsoft Azure

If you require detailed information about installing the virtual machine, uploading the VHD, or using Microsoft Azure in general consult the following guide: Create a Linux VM from custom disk with the Azure CLI 2.0 or, check out the How-to guides under the same link.

This guide only focuses on uploading the VHD and installing SSB.

 Caution:

Hazard of security breach.

During Microsoft Azure installation, connecting directly to the Internet using a public IP address is not supported. Instead, you must access the Internet via a Virtual Private Network or a jump host.

Outils libre-service
Base de connaissances
Notifications et alertes
Support produits
Téléchargements de logiciels
Documentation technique
Forums utilisateurs
Didacticiels vidéo
Flux RSS
Nous contacter
Obtenir une assistance en matière de licence
Support Technique
Afficher tout
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation