Quest® InTrust for Active Directory provides a centralized auditing point allowing you to collect and report on the audit data from Privilege Manager as well as many other data sources you may have in your IT infrastructure.
Figure 10: Audting with InTrust Plug-in
InTrust for Active Directory auditing capabilities allow you to collect and report on the audit data from your Privilege Manager Security system. Featuring a fully automated workflow, InTrust for Active Directory helps you:
InTrust for Active Directory provides reports on the following Privilege Manager System areas:
InTrust for Active Directory supports Privilege Manager version 5.5 and above.
You can collect data from Privilege Manager hosts running on any of the UNIX platforms supported by InTrust.
NOTE: To use the MSI installer for the InTrust Reporting Pack, your InTrust Server must use the Windows SQL Server 2005 as its back-end database.
To configure InTrust for Privilege Manager you must install and configure several components separately. The diagram below shows the major components for the InTrust for Active Directory Plug-in.
Figure 11: InTrust Plug-in components
To install and configure the InTrust for Active Directory Plug-in components
One Identity recommends that you set up a daily cron job to run “pmrun pmintrust.sh” as the pmpolicy service user.
Before you install the InTrust for Active Directory components:
For more information on this process, refer to the InTrust Preparing for Auditing and Monitoring Linux document.
© 2021 One Identity LLC. ALL RIGHTS RESERVED. Feedback Conditions d’utilisation Confidentialité