Tchater maintenant avec le support
Tchattez avec un ingénieur du support

Starling Two-Factor Authentication Hosted - RADIUS Agent Release Notes

Release Notes

One Identity Starling Two-Factor RADIUS Agent 7.3

Release Notes

June 2020

These release notes provide information about the One Identity Starling Two-Factor RADIUS Agent release.


About this release

The One Identity Starling Two-Factor RADIUS Agent utilizes the RADIUS protocol for Two-Factor authentication (push notification or one-time password authentication) through Software as a Service (SaaS). The Starling Two-Factor RADIUS Agent can be used on SaaS and on-premises applications.

Resolved issues

The following is a list of issues addressed in this release.

Table 1: General resolved issues
Resolved Issue Issue ID

Primary authentication fails while connecting from third party VPN providers.


Performance degrades when concurrent users are authenticated from VPN providers.


Primary authentication fails when LDAP over SSL option is enabled.


Primary authentication fails when RADIUS Agent is installed on a machine that is not joined to Active Directory Domain.


Authentication fails when diagnostic logging is enabled for RADIUS Agent.


Initial authentication request to RADIUS Agent fails when the USERNAME & PASSWORD attribute values are empty.


Non-admin User could not install Starling Two-Factor RADIUS Agent on a User Access Control system. 226013

Known issues

The following is a list of issues, including those attributed to third-party products, known to exist at the time of release.

Table 2: General known issues
Known Issue Issue ID

Unable to log in to a different Starling account after failing to connect to Starling.


Close all the RADIUS Agent configuration windows. Open the RADIUS Agent Server configuration tool, and click Connect Starling. Provide credentials of the user who created the Starling account.


Users using 6.x versions of RADIUS Agent with the diagnostic logging set to DEBUG, are reset to default values during an upgrade.


When you upgrade from RADIUS Agent 6.x to 7.x version, perform a manual (first time only) configuration of <log4net debug=”true”> and <level value=”DEBUG”> in the log4net.config file, that is part of the installation directory. These settings are preserved for upgrade from 7.x onwards.


Upgrade and Installation instructions

To upgrade to the latest version of One Identity Starling Two-Factor RADIUS Agent, run the Setup.exe file and follow the on-screen instructions.

In case of upgrade to version 7.x from 6.x, you must connect to a Starling account. When you are upgrading from 7.x to the latest version, the configuration settings will be retained.

For more information on running the installer and Connecting to Starling, refer the One Identity Starling Two-Factor RADIUS Agent Administration Guide.

Outils libre-service
Base de connaissances
Notifications et alertes
Support produits
Téléchargements de logiciels
Documentation technique
Forums utilisateurs
Didacticiels vidéo
Flux RSS
Nous contacter
Obtenir une assistance en matière de licence
Support Technique
Afficher tout
Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation