It can happen that both nodes break down simultaneously (for example because of a power failure), or the slave node breaks down before the original master node recovers. The following describes how to properly recover syslog-ng Store Box (SSB).

NOTE: When both nodes of a cluster boot up in parallel, the node with the 1.2.4.1 HA IP address will become the master node.

To properly recover SSB

  1. Power off both nodes by pressing and releasing the power button.

    Caution:

    Hazard of data loss If SSB does not shut down, press and hold the power button for approximately 4 seconds. However, consider that this method terminates connections passing SSB and might result in data loss.

  2. Power on the node that was the master before SSB broke down. Check the system logs to find out which node was the master before the incident: when a node boots as master, or when a takeover occurs, SSB sends a log message identifying the master node.

    TIP: Configure remote logging to send the log messages of SSB to a remote server where the messages are available even if the logs stored on SSB become inaccessible. For details on configuring remote logging, see SNMP and email alerts.

  3. Wait until this node finishes the boot process.

  4. Power on the other node.