From the Asset Discovery dialog, Schedule tab, configure when you want to run the Asset Discovery job.
Select Run Every to run the job along per the run details you enter. (If you deselect Run Every, the schedule details are lost.)
To specify the frequency without start and end times, select from the following controls. If you want to specify start and end times, go to the Use Time Window selection in this section.
Hours: The job runs per the minute setting you specify. For example, if it is 9 am and you want to run the job every 2 hours at 15 past the hour starting at 9:15 am, you would select Runs Every 2 Hours @ 15 minutes after the hour.
Days: The job runs on the frequency of days and the time you enter.
For example, Every 2 Days @ 11:59:00 PM runs the job every other evening just before midnight.
Weeks The job runs per the frequency of weeks at the time and on the days you specify.
For example, Every 2 Weeks @ 5:00:00 AM and Repeat on these days with MON, WED, FRI selected runs the job every other week at 5 am on Monday, Wednesday, and Friday.
Months: The job runs on the frequency of months at the time and on the day you specify.
For example, If you select Every 2 Months @ 1:00:00 AM along with First Saturday of the month, the job will run at 1 am on the first Saturday of every other month.
Select Use Time Windows if you want to enter the Start and End time. You can click add or - delete to control multiple time restrictions. Each time window must be at least one minute apart and not overlap.
For example, for a job to run every ten minutes every day from 10 pm to 2 am you would enter these values:
Enter Every 10 Minutes and Use Time Windows:
Start 12:00:00 AM and End 2:00:00 AM
An entry of Start 10:00:00 PM and End 2:00:00 AM will result in an error that the end time must be after the start time.
If you have selected Days, Weeks, or Months, you will be able to select the number of times for the job to Repeat in the time window you enter.
For a job to run two times every other day at 10:30 am between the hours of 4 am and 8 pm, you would enter these values:
For days, enter Every 2 Days and set the Use Time Windows as Start 4:00:00 AM and End 20:00:00 PM and Repeat 2.
From the Asset Discovery dialog, Summary tab, review the Asset Discovery job parameters and save it.
Review the following settings:
You can change the settings for an Asset Discovery job
You can delete an Asset Discovery job.
© 2021 One Identity LLC. ALL RIGHTS RESERVED. Feedback Terms of Use Privacy