The following describes how to configure One Identity Safeguard for Privileged Sessions (SPS) to accept connections from external indexer services.

To configure SPS to accept connections from external indexer services

  1. Log in to the SPS web interface, and navigate to Basic Settings > Local Services > Indexer service.

  2. Select Indexer service.

  3. Select Enable remote indexing.

    Figure 5: Basic Settings > Local Services > Indexer service > Enable remote indexing — Configure external indexers

  4. In the Listening addresses > Address field, select the network interface where SPS should accept external indexer connections. Repeat this step to add other interfaces if needed.

    The available addresses correspond to the interface addresses configured in Basic Settings > Network > Interfaces. Only IPv4 addresses can be selected.

  5. Select Restrict clients, and list the IP address and netmask of your external indexer hosts.

    Use an IPv4 address.

  6. Click Commit.