Once the Privilege Manager Console is installed, deploy the Privilege Manager client(s) to the computers on your domain in one of the following ways:
To locate the PM Client MSI setup file:
Open the Privilege Manager Console and then click Additional Resources > Open Client installation folder. The PM Client file will be displayed in the browser window.
To determine if the PM Client has been successfully deployed onto a computer, ensure that:
A special icon with a right-click menu is available in the system tray on the PM Client computer.
The new GPO rules created via Privilege Manager will be applied to the client computers following the group policy update.
(Available only for Privilege Manager Professional)
Note: A PM Server must be configured on your domain before you can use the Client Deployment Settings wizard.
Use the Client Deployment Settings wizard to:
With the Client Deployment Settings, you define:
Once configured, the Client Deployment Settings will be updated and take effect on the client the next time the Group Policy is refreshed on each client.
To Set up/Edit Client Deployment Settings
Step 1. Open the Client Deployment Settings Wizard.
From the Privilege Manager Console, launch the Client Deployment Settings Wizard within the Setup Tasks section to add the settings to any available GPO.
Or,
Double-click Client Deployment Settings on the Advanced Policy Settings tab of the target GPO to change the settings for the currently selected GPO.
Note: The Client Deployment Settings wizard run from the Setup tasks section always shows the default settings. The changes made within the wizard are saved to the Client Deployment Settings wizard of the target GPO on the Advanced Policy Settings tab.
Choose what to perform with the client.
Choose whether to install or remove the PM Client software, or stop the GPO settings from applying.
Click Next.
Settings Tab - Define the PM Server.
Click OK.
Quit the wizard or customize the GPO setting.
Click Next to modify the default settings or click Finish to save the default settings for the target GPO and quit.
(Optional) Perform this additional configuration:
Use the Validation Logic tab to target the settings to specific PM Client computers within the GPO. Click Next.
Note: The Client Deployment Settings can be targeted only to certain computers and not to user accounts or groups.
(If applicable) Save the modified GPO settings.
Click Save on the GPO toolbar to save the newly defined GPO settings.
Double-click Client Deployment Settings on the Advanced Policy Settings tab of the desired GPO to view the currently configured Client Deployment Settings.
© 2025 One Identity LLC. ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center