-
标题
SPS is currently operating in "Degraded (Disk Error)" state. -
说明
The High Availability and Nodes status is showing that SPS is currently operating in Degraded (Disk Error) state.
Performing a restart does not solve the problem, the error still persists. -
原因
This usually happens when the hardware RAID controller loses the SATA link of a disk during heavy I/O. This results in degradation or, in the worst cases, an offline RAID array. Normally, the disk must reappear after a reboot and degraded arrays should be rebuilt automatically.
However, under certain conditions, the firmware on the disks may not react in time to the controller if the NCQ (Native Command Queueing) function is enabled.
-
解决办法
The solution is to tell the controller to disable The NCQ feature.
To do this, log on to the system via SSH, and start a boot shell and execute the following command:
arcconf SETNCQ 1 disable
The system must be restarted for the change to take effect.
In case the above steps do not work, please contact One Identity support.
-
其他信息
This applies to T4 and T10 appliances. Hardware specifications can be found here.