立即与支持人员聊天
与支持团队交流

Identity Manager 9.2.1 - Web Application Configuration Guide

About this guide Managing the API Server Configuring API projects and web applications
General configuration Configuring the Administration Portal Configuring the Password Reset Portal Configuring the Web Portal
Recommendations for secure operation of web applications

Using HTTPS

Always run the One Identity Manager's web application over the secure communications protocol "Hypertext Transfer Protocol Secure" (HTTPS).

In order for the web application to use the secure communications protocol, you can force the use of the "Secure Sockets Layer" (SSL) when you install the application. For more information for using HTTPS/SSL, see the One Identity Manager Installation Guide.

Disabling the HTTP request method TRACE

The TRACE request allows the path to the web server to be traced and to check that data is transferred there correctly. This allows a trace route to be determined at application level, meaning the path to the web server over various proxies. This method is particularly useful for debugging connections.

IMPORTANT: TRACE should not be enable in a productive environment because it can reduce performance.

To disable the HTTP request method TRACE using Internet Information Services

  • You will find instructions by following this link:

https://docs.microsoft.com/iis/configuration/system.webserver/tracing/

Disabling insecure encryption mechanisms

It is recommended that you disable all unnecessary encryption methods and protocols on the grounds of security. If you disable redundant protocols and methods, older platforms and systems may not be able to establish connections with web applications anymore. Therefore, you must decide which protocols and methods are necessary, based on the platforms required.

NOTE: The software "IIS Crypto" from Nartac Software is recommended for disabling encryption methods and protocols.

For more information about disabling, see here.

Detailed information about this topic

Removing the HTTP response header in Windows IIS

Attackers can obtain a lot of information about your servers and network by looking at the response header your server returns.

To give attackers a little information as possible, you can remove the HTTP response header in Windows IIS.

To remove the HTTP response header in Windows IIS

相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级