NOTE: The following sequence describes how you configure a synchronization project if the Synchronization Editor is in expert mode.
To set up initial synchronization project for Top Secret
-
Start the Synchronization Editor and log in.
-
From the start page, select Start a new synchronization project.
This starts the Synchronization Editor's project wizard.
-
On the Choose target system page, select Top Secret LDAP Connector.
-
On the System access page, click Next.
-
On the Create system connection page, select Create new system connection.
-
On the system connection wizard start page, click Next.
-
On the Network page:
-
In the Server field, enter the DNS name or IP address of your mainframe server.
-
In the Port field, enter the port number.
-
Click the Test button to make sure the server is accessible.
-
CA LDAP Server for z/OS supports LDAP v3. Enter the number 3 in the Protocol version.
-
If SSL is to be used, check the Use SSL box.
-
-
On the Authentication page:
-
Set the Authentication method to Basic.
-
In the Credentials section, enter the full DN and password of the administrator account on your Top Secret system.
-
Click Test to check that the credentials are valid.
The schema is loaded from the Top Secret system.
-
-
Ignore the Define virtual classes page. Click Next.
-
On the Search options page:
-
In the Base DN drop-down, and select the correct base DN for your system.
-
Ignore the Use partitioned search check box.
-
-
Ignore the Modification capabilities page. Click Next.
-
Ignore the Auxiliary class assignment page. Click Next.
-
Ignore the System attributes page. Click Next.
-
Ignore the Select dynamic group attributes page. Click Next.
- Ignore the Password settings page. Click Next.
-
Click Finish.
This takes you back to the Synchronization Editor project wizard.
-
On the One Identity Manager connection page, enter the database connection data.
This Top Secret schema loads into your One Identity Manager system. Wait for this to complete.
-
On the Select project template page, select Create blank project.
-
On the General page, enter a display name for your synchronization project and set a scripting language if required.
-
Click Finish.
-
Select Activate project.