Tchater maintenant avec le support
Tchattez avec un ingénieur du support

One Identity Safeguard for Privileged Passwords 7.5 - Connect for Safeguard Assets User Guide

Removing an installed agent

The following instructions are for removing a previously installed agent. This will only remove the agent from the asset, no changes will be made to Safeguard for Privileged Passwords.

To remove an installed agent

  1. On the asset the agent is installed, open a Command Prompt or PowerShell session.

  2. Run the Remove command on ConnectForSafeguardAssetsAgent.

    Once the agent has been removed, you can either remove any corresponding assets within Safeguard for Privileged Passwords or enroll a new token (for more information, see Downloading an Agent Enrollment token).

Collaborators

Topics:

Introduction to Collaborators

Connect for Safeguard Assets allows users to add collaborators to their service. Adding additional collaborators is optional and can be done at any time using the Collaborators page.

Collaborators page

The Collaborators page is displayed when Collaborators is clicked in the navigation bar. The Collaborators page is used for adding and managing the collaborators currently associated with the Connect for Safeguard Assets service.

The following options appear on this page:

Invite Collaborator

Clicking this button opens the Invite Collaborator dialog so you can add new collaborators to your Connect for Safeguard Assets service. For more information, see Adding additional collaborators or Adding additional Azure AD work account collaborators.

This field is used to search for a user based on their name or email. To use the search functionality, start typing in the field. The table will automatically update to display results that match.

The following information and options appear in the table on this page:

Name

This displays the name specified in the collaborator invite.

Email

This displays the email address associated with the collaborator.

Status

This displays the status of the collaborator. When a collaborator is added they will be marked as Invited until the invitation has been accepted, at which point the Status column will update to display Registered. If an Administrator has selected to remove a collaborator, a status of Pending Removal will appear until the request has been approved or rejected.

The button appearing for a collaborator contains the following options depending on the current status of the collaborator.

  • Remove Collaborator: Available for a confirmed collaborator, select this option to remove the collaborator from Connect for Safeguard Assets.For more information, see Removing collaborators.
  • Re-send Invitation: Available for an invited collaborator, selecting this option re-sends the invitation to the selected collaborator if they have not yet accepted. For more information, see Re-sending collaborator invitation.
  • Cancel Invitation: Available for an invited collaborator, selecting this option cancels the invitation to the selected collaborator if they have not yet accepted. For more information, see Canceling collaborator invitation.

NOTE: You are unable to manage your own collaborator account.

Documents connexes

The document was helpful.

Sélectionner une évaluation

I easily found the information I needed.

Sélectionner une évaluation