지금 지원 담당자와 채팅
지원 담당자와 채팅

Identity Manager 9.2.1 - Compliance Rules Administration Guide

Compliance rules and identity audit
One Identity Manager users for identity audit Basic data for setting up rules Setting up a rule base rule check Mail templates for notifying about identity auditing
Mitigating controls for compliance rules Configuration parameters for Identity Audit

Enabling and disabling compliance rules

Enable the rule so that rule violation can be found. To exclude rules from testing, you can disable them. Any existing rule violations are removed by the DBQueue Processor. The working copy rule is always disabled.

To enable a rule

  1. In the Manager, select the Identity Audit > Rules category.

  2. Select the rule in the result list.

  3. Select the Enable rule task.

To display a rule

  1. In the Manager, select the Identity Audit > Rules category.

  2. Select the rule in the result list.

  3. Select the Disable rule task.

Recalculating

There are several tasks available for a rule, which immediately perform a rule check. For more information, see Checking compliance rules.

Copying compliance rules

Rules can be copied to reuse complex rule conditions, for example. Working copies as well as active rules can be used as copy templates.

To enable a rule

  1. In the Manager, select the Identity Audit > Rules category.

  2. Select the rule in the result list.

  3. Select the Change main data task.

  4. Select the Copy rule task.

  1. Enter a name for the copy and click OK.

    This creates a working copy with the given name.

  2. Click Yes to immediately edit the copy's main data.

    - OR -

    Click Yes to edit the copy's main data later.

Maintaining exception approvers

Use this task to maintain exception approvers for the selected rule. To do this, assign identities that are allowed to approve exceptions to this rule to the applications roles entered for exception approvers on the main data form.

NOTE: Changes apply to all the rules assigned to this application role.

To authorize identities as exception approvers

  1. In the Manager, select the Identity Audit > Rules category.

  2. Select the rule in the result list.

  3. Select the Maintain exception approvers task.

  4. In the Add assignments pane, add identities.

    TIP: In the Remove assignments pane, you can remove assigned identities.

    To remove an assignment

    • Select the identity and double-click .

  5. Save the changes.
Related topics
관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택