To delete a password sync rule
- In the Quick Connect Administration Console, open the Password Sync tab.
- Locate the rule you want to delete, and then click Delete this rule below the rule.
To delete a password sync rule
You can modify the following settings of an existing password sync rule:
To modify the settings of a password sync rule
This section provides information about the optional tasks related to configuring the automated password synchronization from an Active Directory domain to connected data systems.
In this section:
Capture Agent has a number of parameters you can modify. After you install the agent, each of these parameters is assigned a default value, as described in the following table:
Parameter |
Description |
Default value |
Maximum connection point age |
Determines the period of time (in hours) during which a connection between Capture Agent and Quick Connect Service remains valid. |
24 hours |
Set interval between attempts to reconnect to service |
Determines the time interval (in minutes) during which Capture Agent tries to reconnect to Quick Connect Service. |
10 minutes |
Set time period for attempts to connect to service |
Determines the period of time (in days) during which Capture Agent tries to connect to Quick Connect Service to send the information about changed user passwords. During this period Capture Agent stores the user passwords to be synchronized in an encrypted file. |
7 days |
Set certificate |
Specifies a certificate for encrypting the password sync data transferred between Capture Agent and Quick Connect Service. For more information, see Specifying a custom certificate for encrypting password sync traffic. |
By default, a built-in certificate is used. |
Connection Point 1 |
Define the Quick Connect Service instances to which Capture Agent provides information about changed user passwords. |
If none of these parameters is set, Capture Agent looks for available instances of the Quick Connect Service in the following container: CN=QuickConnect,CN=One Identity,CN=System,DC=<DomainName> |
Connection Point 2 | ||
Connection Point 3 | ||
Connection Point 4 | ||
Connection Point 5 | ||
Connection Point 6 | ||
Connection Point 7 |
You can modify the default values of these parameters by using Group Policy and the Administrative Template supplied with the One Identity Quick Connect Sync Engine. The next steps assume that all the domain controllers where the Capture Agent is installed are held within organizational units.
Complete these steps to modify the default Capture Agent settings:
© ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center