To use connectors remotely, you need to install Synchronization Service and built-in connectors on a required remote computer and switch the installed instance of Synchronization Service to remote mode. For more information on installing Synchronization Service, see Installing Synchronization Service.
To set Synchronization Service in remote mode
-
Start the Synchronization Service Console.
-
Follow the steps in the wizard that starts automatically to configure Synchronization Service.
-
On the Service Account and Mode page, do the following and click Finish:
-
Enter the account under which you want Synchronization Service to run.
-
Select the remote mode for this instance of Synchronization Service.
-