Chatee ahora con Soporte
Chat con el soporte

Privilege Manager for Unix 7.3 - Release Notes

Upgrade and installation instructions

NOTE: Due to a change in the communication protocol, using 7.1 or later clients and servers with 7.0 clients and servers is not supported. One Identity recommends you upgrade all of your 7.0 installations to 7.1 or later versions. Installations of release 6.x are not affected and can still be used with 7.1.

Upgrade instructions

For information on upgrading Privilege Manager for Unix, see Upgrade Privilege Manager for Unix in Privilege Manager for Unix Administration Guide.

Upgrading your license

Depending on whether you are upgrading Privilege Manager for Unix from a version earlier than 7.0 or from version 7.x, handling your license is different.

  • Upgrading from a version 7.x: If you have purchased Privilege Manager for Unix version 7.x without owning an earlier version, you will receive a new license. In this case, you do not have to perform any extra steps and can proceed with the upgrade process.

  • Upgrading from a version earlier than 7.0: The product licensing changed with Privilege Manager for Unix version 7.0. If you are upgrading Privilege Manager for Unix from a version earlier than 7.0 to version 7.x, you must upgrade your license first.

    In this case, make sure that you have received you upgraded license before starting the upgrade process.

When client machines attempt to join to the policy server using the pmjoin or pmjoin_plugin command, if you do not have the proper license, the following error message is displayed:

*** Checking connection to policy server host <policy-server>           [FAIL]
- ERROR: policy server <policy-server> has no valid license (for QPM4U)
- ERROR: Unable to connect to any policy servers

To display a summary of the combined licenses configured on this host, enter the following command without any options

pmlicense

To install a license, enter the following command. For more information on license installation, see Installing licenses in Privilege Manager for Unix Administration Guide.

pmlicense -l <path-to-dlv-file>
  • If the license file is valid, the installer displays the following:

    The selected license file (<path-to-dlv-file>) contains a valid license
  • If the license file is not valid, the installer displays the following error:

    Error: This license file is not valid. Please contact Quest Licensing for a new license file.

You will receive the following message after the license is installed, depending the success of the installation:

  • If the license is successfully installed:

    ** Successfully installed new license
  • If the license install is failed:

    ** Error: Cannot configure new license from file <path-to-dlv-file>

More resources

Additional information is available from the following:

Globalization

This section contains information about installing and operating this product in non-English configurations, such as those needed by customers outside of North America. This section does not replace the materials about supported platforms and configurations found elsewhere in the product documentation.

This release is Unicode-enabled and supports any character set. In this release, all product components should be configured to use the same or compatible character encodings and should be installed to use the same locale and regional options. This release is targeted to support operations in the following regions: North America, Western Europe and Latin America.

Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación