戻る
-
タイトル
Moving a TPAM Replica to a new location -
説明
Moving a TPAM Replica to a new location
-
対策
Here is a general breakdown of the recommend process for moving your Replica.
- Login to the /paradmin interface on your Primary and go to the HA Settings page.
- Change the Primary to Standalone mode and Save Changes. (This will prevent it from looking for the absent Replica while it is offline)
- Click the Shutdown button for the Replica.- Once the Replica is setup in the new location, turn it on and allow it to boot.
- I would recommend connecting a monitor and keyboard so you can verify it booted properly.
- If you received the "Encryption Login" during boot, enter the default username and password- Login to the /paradmin interface on your Primary and go to the HA Settings page.
- Change the Primary to Replicating mode and Save Changes.
- This change in mode will automatically initiate a backup on the Primary and a replication to the Replica.
- Monitor the Primary Log and Replica Log to ensure communication is successful.If you have any trouble with these steps or experience communication failure between the appliances, contact Quest Support for further assistance.