To create a synchronization configuration for synchronizing Exchange Online
In the Synchronization Editor, open the synchronization project.
Create a new workflow with the workflow wizard.
This creates a workflow with Target system as its direction of synchronization.
Create a new start up configuration. Use the new workflow to do this.
Run a consistency check.
When you set up synchronization for the first time, the system connection properties are set to default values that you can modify. There are two ways to do this:
Specify a specialized variable set and change the values of the affected variables.
The default values remain untouched in the default variable set. The variables can be reset to the default values at any time. (Recommended action).
Edit the target system connection with the system connection wizard and change the effected values.
The system connection wizard supplies additional explanations of the settings. The default values can only be restored under particular conditions.
To customize connection parameters in a specialized variable set
In the Synchronization Editor, open the synchronization project.
Select the Configuration > Target system category.
Open the Connection parameters view.
Some connection parameters can be converted to variables here. For other parameters, variables are already created.
Select a parameter and click Convert.
Select the Configuration > Variables category.
All specialized variable sets are shown in the lower part of the document view.
Select a specialized variable set or click on 
To rename the variable set, select the variable set and click the variable set view in the toolbar 
Select the previously added variable and enter a new value.
Select the Configuration > Start up configurations category.
Select a start up configuration and click Edit.
Select the General tab.
Select the specialized variable set in the Variable set menu.
Select the Configuration > Base objects category.
Select the base object and click 
- OR -
To add a new base object, click
Select the specialized variable set in the Variable set menu.
For more information about using variables and variable sets, or restoring default values and adding base objects, see the One Identity Manager Target System Synchronization Reference Guide.
NOTE: In the following circumstances, the default values cannot be restored:
The connection parameters are not defined as variables.
The default variable set is selected as an active variable set.
In both these cases, the system connection wizard overwrites the default values. They cannot be restored at a later time.
To edit connection parameters using the system connection wizard
In the Synchronization Editor, open the synchronization project.
In the toolbar, select the active variable set to be used for the connection to the target system.
NOTE: If the default variable set is selected, the default values are overwritten and cannot be restored at a later time.
Select the Configuration > Target system category.
Click Edit connection.
This starts the system connection wizard.
Follow the system connection wizard instructions and change the relevant properties.
© ALL RIGHTS RESERVED. Feedback 이용 약관 개인정보 보호정책 Cookie Preference Center
