Syntax
return [expression];
Description
return exits the current procedure/function and returns the value of expression.
Examples
function square (n){
n2 = n * n;
return n2;
}
print(square(10)); // prints "100"return [expression];
return exits the current procedure/function and returns the value of expression.
function square (n){
n2 = n * n;
return n2;
}
print(square(10)); // prints "100"switch (string)
{
case expression1:
statement1a; [statement1b; …] [break;]
case expression2:
statement2a; [statement2b; …] [break;]
default: statement3a; [statement3b; …] [break;]
}The switch statement tests whether an expression matches one of several values (each of which is specified in a case statement) and branches accordingly. If a case matches the value, execution will begin at that case falling through to subsequent cases until a break statement occurs. The break statement forces an immediate exit from the switch statement; it is optional.
The default statement runs if none of the cases match the value. This statement is optional. If there is no default and none of the cases match the value, nothing happens. Case statements can be in any order, but the default statement, if present, must occur after all of the case statements.
switch (user) {
case "leslie":
runuser="sys";
break;
case "adrian":
accept;
case "cory":
case "jamie":
runuser = "root";
accept;
default:
reject;
}
switch (gidnum){
case 0: runuser="root"; break;
default: break;
}For additional usage examples, see Example 9: Switch and case statements.
while ( expression ) statement
The while statement is a looping statement. It repeatedly runs the specified statement while the specified expression evaluates to true (any non-zero value). The while statement terminates when the specified expression evaluates to false (the value 0) or it encounters a break statement.
The specified statement may not run if the specified expression initially evaluates to false (unlike the do-while statement, which always runs its specified statement at least once).
Use a statement block in the form { statement ... } to run multiple statements in the loop. One Identity recommends using a statement block for readability.
This prints the values 1,2,3,4,5:
x = 1; while (x <= 5) print(x++);
This prints the values 1,2,3,4,5 and uses a statement block:
x = 1;
while (x <= 5) {
print(x);
x++;
}
This prints the values 1,2,3 because the break statement terminates the loop:
x=1;
while (x <= 5) {
if (x > 3) break;
print(x++);
}For more usage examples, see Use the while loop.
This section documents the syntax and usage of the built-in functions and procedures that are available to use within the policy file. They are listed in the following categories:
© 2024 One Identity LLC. ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center