-
タイトル
How to configure the Dell Remote Access Card (DRAC) on the TPAM appliance? -
説明
How to configure the Dell Remote Access Card (DRAC) on the TPAM appliance?
Is there documentation for DRAC / iDRAC FAQ or configuration? -
対策
1. What is the iDRAC / DRAC?
The Integrated Dell Remote Access Controller is an out-of-band management card shipped on all TPAM Dell appliances.
2. Is the DRAC required for TPAM?
The intention of the DRAC is for remote power operations, and to view the TPAM Kiosk where physical access may be problematic. The DRAC is provided on all TPAM hardware as a customer convenience, its usage is optional, and has no impact TPAM.
3. Does One Identity provide setup / configuration documentation?
No, setup documentation and a video are available from Dell:
4. Does One Identity provide support for the DRAC?One Identity provide hardware support only for the DRAC (I.e. if the DRAC fails, and the TPAM device has maintenance we will RMA the TPAM appliance.)
5. Can the firmware of the DRAC be upgraded on TPAM devices?It is not supported or advisable. Due to security in place on TPAM devices updating the firmware can cause devices to become unbootable. More information can be found here
Information on upgrading firmware is available from Dell
Dell PowerEdge: How to a Remote Firmware Update with the iDRAC?6. Can the DRAC card be rebooted / power cycled?
Yes, the DRAC can be soft restarted without powering down the server. Press and hold down the System identification "i" button on the device for more than 15 seconds.
Refer to Dell documentation How to reset the internal Dell Remote Access Controller (iDRAC) on a PowerEdge server?7. Can the DRAC card settings be reset to default settings?
Yes, to reset the settings:
1. Reboot the server and press during the Power-on Self-test (POST).2. In the System Setup Main Menu page, click iDRAC Settings.3. Click "Reset iDRAC configurations to defaults"4. Click Yes to confirm, and then click Back.5. Click Finish.6. The reset is now complete. Please configure the DRAC as per the normal procedure setting the IP address etc.
8. What is the default username / password for the DRAC card?The defaults are below, more information can be found in the Dell iDRAC User Guides
un: root
pw: calvin
9. If the root password has been lost can it be reset?To reset the root password:
1. Reboot the server and press F2 during the Power-on Self-test (POST). (View the prompts on screen)2. In the System Setup Main Menu page, click iDRAC Settings.3. Click "User Configuration".4. In the Change Password fieldfor user root, enter the new password.5. Click Back, click Finish, and then click Yes. The details are saved.
10. What ports are required to access the DRAC card?
Refer to Dell documentation iDRAC 8/7 v2.30.30.30 User’s Guide
12. Our scanning software identify a vulnerability on the DRAC network IP
We are unable to comment on Dell DRAC security concerns. If you have any concerns, the DRAC can be disconnected from the network - this will not impact TPAM. Alternatively, configure the DRAC on its own protected isolated network.
Other Useful Links
Event and Error Message Reference Guide (RAC Errors)Dell Remote Access Controller wiki
Dell Techcenter community forum
iDRAC7 Manuals and user guides
Dell Owners Manual R320, R420, R430