Advanced and Diagnostic Settings for the Password Capture Agent
Advanced and Diagnostic Settings for the Password Capture Agent
The Password Capture Agent offers several registry settings for diagnostic and special purposes. These parameters can be set in the registry. You will find them in the Registry Editor underneath the path HKEY_LOCAL_MACHINE\SOFTWARE\One Identity\One Identity Manager\Password Capture Agent\Driver.
|
|
NOTE: No reboot is required to take effect. |
Detailed information about this topic
- DeactivateOnStart
- Diagnostic
- DiagnosticBeepFrequency
- FaultToleranceWaitTimeBeforeRetryInSeconds
- LogFile
- PendingCapturesArchiveDepthInDays
- Synchronous
- Ignoring\UserNames
- Ignoring\UserRids
DeactivateOnStart
- Type: REG_DWORD
- Unit: switch (on/off)
- Default: 0 (= off)
Disable password change without uninstalling. If the value is set to 1 the Password Capture Agent will be disabled after the next reboot. The only action after reboot is a single hint, logged to the Password Capture Agent Event Log - named One Identity Manager Password Capture Agent - in the Windows Event Viewer.
Diagnostic
- Type: REG_DWORD
- Unit: Switch (on/off)
- Default: 0 (= off)
Enables some diagnostic behavior if this parameter is set to 1.
- Verbose logging to log file if it is specified (Registry Parameter LogFile). Every operation and its result will be logged.
- All logging will also be sent as an operating system debug message for appropriate live viewers (e.g. DebugView from Windows Sysinternals).
- In Windows Server every message to the Password Capture Agent event log in Windows Event Viewer will be additionally noted with a beep tone. Where an error message will be noted with a deep Tone: 200 Hz, a warning message will be noted with a middle-high tone: 1000 Hz, an info message will be noted with a high tone: 2000 Hz. This is only available in Windows Server 2003 service pack 2.
- The registry parameter DiagnosticBeepFrequency is enabled.
- The registry parameter LogFile is enabled.
Related Topics
DiagnosticBeepFrequency
- Type: REG_DWORD
- Unit: tone frequency in Hz
- Default: 0
In Windows Server if is parameter Diagnostic is enabled, every diagnostic log message will be noted with a beep tone in the specified frequency. This is only available in Windows Server 2003 service pack 2.