To run the provisioning step:
-
On the Sync Workflows tab, click Run now.
-
In the Select sync workflow steps to run dialog, select the check box next to the step you created, and then to run the step, click Full Run.
After the synchronization step run completes, the Console displays a report that provides information about the objects that participated in the provisioning step. At this stage, the application does not commit changes to the target One Identity Manager domain.
To commit the changes to One Identity Manager
An All changes committed message is displayed. The changes are committed from the source Active Directory Test AD to the target One Identity Manager.
To verify if the data is synchronized to One Identity Manager
-
Open the .
-
Verify that all the users from the AD are synchronized with One Identity Manager as per the provisioning rules that were set.
The deprovision operation in data synchronization using allows you to modify or remove objects in the target data system after their counterparts have been disconnected from the source data system. You can configure to remove target objects permanently or change them to a specific state. To specify the objects that will participate in the deprovision operation you can use object mapping rules. This scenario describes how to create a deprovisioning step for a workflow to modify or delete the synchronized objects in the target system based on the deprovisioning criteria that is set.
To create a deprovisioning step
-
In the Console, open the Sync Workflows tab, and then click the AD to OneIM Sync workflow.
-
Click Add synchronization step.
-
In the Select an action dialog, select Deprovision, and then click Next.
-
In the Specify source and criteria dialog, click Specify, click Add new connected system or Select existing connected system, and then step through the wizard to add the Active Directory Test AD as a connected system.
-
Specify a deprovisioning criteria by selecting one of the following:
-
Source object is deleted or out of synchronization scope
-
Source object deprovisioning is initiated in connected system
-
Source object meets these criteria - Add the criteria for the source objects to be deprovisioned in the target system
-
Click Next.
-
In the Specify target dialog, click Specify.
-
Click Add new connected system or Select existing connected system, and then step through the wizard to add the target One Identity Manager domain as a connected system.
-
Click Select, to add the required target object type.
-
In the Select Object Type dialog, select the UNSAccountB object type from the list of object types and click OK.
-
In the Specify deprovisioning action dialog, select the one of the following action to deprovision:
-
Click Next.
Active Roles then creates the deprovisioning step with the rules for the specified deprovisioning action.
