Use configuration parameters to configure the behavior of the system's basic settings. One Identity Manager provides default settings for various configuration parameters. Check the configuration parameters and modify them as necessary to suit your requirements.
Configuration parameters are defined in the One Identity Manager modules. Each One Identity Manager module can also install configuration parameters. In the Designer, you can find an overview of all configuration parameters in the Base data > General > Configuration parameters category.
Detailed information about this topic
The configuration parameters supplied and their permitted values are maintained by the schema installation. You cannot edit the properties of these parameters. You can set or unset them and specify the actual value for the parameter. Other properties of predefined configuration parameters cannot be edited. Changing a configuration parameter can result in calculations for the DBQueue Processor.
IMPORTANT: If the configuration parameter is preprocessor relevant, compile the database after it changes.
TIP: In the Designer, in the hierarchical view of the Configuration Parameter Editor, modified configuration parameters are framed in yellow 
.
To edit configuration parameters
-
In the Designer, select the Base data > General > Configuration parameters category.
-
Select the configuration parameter in the Configuration Parameter Editor.
-
In the Configuration parameter view, select the Properties tab.
-
Customize the following settings.
-
Enabled: Specifies whether the configuration parameter is set. To set the configuration parameter, select the check box. To unset the configuration parameter, clear the check box.
-
Value: Value of the configuration parameter.
TIP: You can edit the values of some configuration parameters in the Configuration Parameter Editor in a separate wizard. Click ... next to the input field to start the wizard.
-
Select the Database > Commit to database and click Save.
Related topics
If it is necessary to define other custom configuration parameters, you can add them below the Custom configuration parameter.
To set up a new configuration parameter
-
In the Designer, select the Base data > General > Configuration parameters category.
-
Select the Custom configuration parameter and use the Insert context menu to insert a new configuration parameter.
-
In the Configuration parameter view on the Properties tab, edit the main data of the configuration parameter.
-
(Optional) If a configuration parameter only permits certain values, specify the permitted values on the Options tab.
-
To create a new option, click Insert.
-
To deleted and option, click Delete.
-
Select the Database > Commit to database and click Save.
Related topics
